The ADEM 2C Headrest for Hard Shell seats

adem2 euromesh

All headrests are now pre-drilled for the SuperFlash Tail Light Bracket

The ADEM 2 readily attaches to Hard Shell seats using the four #8 self-threading screws, which thread into the plastic bracket eliminating the need for nuts. All fasteners are stainless steel. Installation requires only drilling four 3/16" dia. holes in the seat shell.

Vertical adjustment and complete removal of the mast is easily accomplished by simply flexing the locking tab to disengage the velcro. Adjustment can even be made without leaving the seat.

Fore/aft adjustment is made by minor bending of the aluminum mast.

The ADEM 2C comes standard with the extremely comfortable Upholstered Pad with water-proof, fast-drying and breathable EZ-Dri foam and a washable cover. The comfort of the pad is enhanced with two layers of foam. The soft top layer gently conforms to to the neck and the bottom layer is firmer for support and longevity.

The Standard version will fit most riders up to about 6 ft. tall. The Tall version provides an additional 2.5" of height.

CAUTION: Select the correct size for your height. Do not overextend the mast height or failure of the mounting bracket could result and potentially cause in loss of control. A MAX mark is provided on the mast to indicate max extension.

To see sizing details, please click on the tab below

 

ADEM 2C Standard: $120

 

ADEM 2C Tall: $130

 

Back to Store index page

Click Here to Show / Hide Sizing details

The following photos show the correct location of the pad against the head and illustrate the range of height adjustment available with the standard ADEM 2.

NOTE that the pad is against the NECK and BELOW THE HELMET

min. height 2 inchesmax height 6 inches

The adjustment range of the standard ADEM 2 is 2" to 6" as shown.

The adjustment range of the ADEM 2 Tall is 5" to 8.5".

The Upholstered Pad has an additional set of offset mounting holes which can be used to extend the range 1 inch either higher or lower.